Is a EC motor with sinusoidal commutation stronger?
The difficulty answering this question is to find and to define reasonable references. We restrict us here on current and torque considerations.
- motor data in the catalog are given for block commutation.
- the reference current of the block commutation is the value of the block current in each commutation intervall IB.
- due to the torque ripple, only the average torque is considered.
- hence, the torque constant of block commutation kM,B gives the average torque per IB.
- the current reference with sinusoidal commutation is defined as the amplitude of the sinusoidal phase current IS.
- the torque shows no ripple with sinusoidal commutation. No averaging is needed
- the torque constant of the sinusoidal commutation kM,S is defined as the ratio of the produced torque and the reference current IS.
Results for sinusoidal commutation:
- the max. continuous current is about 15% higher with sinusoidal commutation.
- the torque constant is about 10% smaller with sinusoidal commutation.
- the max. continuous torque is about 5% higher with sinusoidal commutation.
- Hence, the continuous operation range is enlarged by about 5%.
See also the attachments SinusBlockkommutierung.PDF (german) and SineCommutationMMC.PDF (english) (with information about space vector control) below.
Remark for flat motors at stand still
In flat motors operated with sinusoidal commutation at stand still (e.g. in a positioning system with EPOS controller), one phase winding can overheat due to the special arrangement of the winding. Therefore, the continuous current limitation of the controller should be set to 85% of the motors rated current.